Filter
Top Products
Installing a new G700 without an S8300 using the Gateway Installation Wizard
210 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Administering IP Interfaces
This procedure assigns network region 1, as an example, to the S8300 media server.
To assign the network region and IP endpoint access to the S8300
1. At the SAT prompt, type change ip-interfaces procr.
The S8300 displays the IP Interfaces screen for the media server.
IP Interfaces Screen
2. The field Enable Ethernet Port? should indicate y (yes). The Node Name should be the IP
address of the S8300 media server.
3. In the Allow H.323 Endpoints field, enter a ’y’ to allow H.323 endpoint connectivity to the
server.
4. In the Allow H.248 Endpoints field, enter a ’y’ to allow H.248 media gateway connectivity
to the server.
5. In the Gatekeeper Priority field, enter a value is used on the alternate gatekeeper list. The
lower the number the higher the priority. Valid values for this field are one through nine with
five being the default. This field displays only if the allow H.323 endpoints field is set to y.
Identifying LSPs to the S8300 primary controller
If the primary controller has LSPs, you must enter the LSP node names on the Survivable
Processor form to enable the LSPs to get translations updates from the primary controller. Once
the LSPs are successfully entered on the LSP screen, their status can be viewed with the list
survivable-processor command.
Note:
Note: The LSP node names must be administered on the node-names-ip form before
they can be entered on the Survivable Processor screen.
change ip-interfaces procr Page 1 of 1
IP INTERFACES
Type: PROCR
Node Name: procr
IP Address: 135.9.41.146
Subnet Mask: 255.255.255.0
Enable Ethernet Port? y Allow H.323 Endpoints? y
Nework Region: 1 Allow H.248 Gateways? y
Gatekeeper Priority: 5