Filter
Top Products
Manual installation of a new G700 without an S8300
564 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
<tftp_server_ip_address> is the IP address of the TFTP server, and
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only
one G700 media gateway, the number is 1.
3. Verify that the download was successful when the prompt returns:
a. type show image version <module #> and check the version number in the
Version column for Bank B.
b. type dir <module #> and check the version number in the ver num column for the
EW_Archive file.
4. Type reset <module #>.
Installing new firmware on the G700 Media Gateway Processor
To install MGP firmware
1. At the P330-1(configure)# prompt, type session mgp to reach the G700 media gateway
processor.
2. Type configure at the MG-???-1(super)# prompt to enter configuration mode, which will
change the prompt to MG-???-1(configure)#.
3. At the MG-???-1(configure)# prompt, type show mgp bootimage to determine which
disk partition (bank) is in the Active Now column.
You will update the bank that is not listed as Active Now. The system displays the following
screen:
Example: Show mgp bootimage
4. At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700,
where
<bank> is the bank that is not Active Now (Bank A in the example).
<filename> is the full path name of the mgp firmware image file, which begins with mgp
and will be similar to the name mgp_8_0.bin.
FLASH MEMORY IMAGE VERSION
Bank A 109
Bank B 210
ACTIVE NOW
ACTIVE AFTER REBOOT
Bank B Bank B