Filter
Top Products
About navigation for G700 CLI commands
Issue 9.1 June 2006 81
About navigation for G700 CLI commands
Table 3 describes a few Command Line Interface commands that you will need to navigate
among the processors on the G700.
Note:
Note: This navigational aid assumes that you are logged in to the P330 Stack
Processor. Default mode is Supervisor with a P330-1(super)# command-line
prompt.
The command-line prompts in an MGP session use the media gateway name that is assigned
when the gateway is configured.
You can telnet to another processor from a current telnet session.
Table 3: Navigational aid for G700 CLI commands
Command Purpose Prompt
super change to supervisor
mode
P330-y(super)#
or <MG-xxx>-y(super)#
where xxx is the media gateway
number assigned on the add
media-gateway form, and y is the
"module number" of the G700 in the
stack.
configure change to
configuration mode
P330-1(configure)#
or <MG-001>-1(configure)#
session <module #>
mgp
(from a stack processor
session)
open a CLI session on
the mgp processor
<MG-001>-1(super)#
session <module #>
stack
(from an MGP session)
open a CLI session on
the stack processor
P330-1(super)#
session icc
(from an MGP session)
open a CLI session on
the S8300 processor
craft@<host name>>
session <#> open a session on the
stack processor in
module (i.e. another
G700)<#> in the stack
P330-<#>(super)#
exit close the current
session (and revert to
the previous session)
<command> help displays help for
<command>