Filter
Top Products
Manual installation of a new G700 without an S8300
574 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Figure 51: Add Local Survivable Processor screen
2. The type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
3. Enter a network region for the LSP. The default is 1. However, there may be a different
network region better suited for the LSP to provide media gateway and IP phone support.
Skip to Administering the Media Gateway
on page 584 to continue.
Administering an S8400, S8500, or S8700-series primary
controller
Complete the procedures in this section if the primary controller for the G700 you are installing
is an S8400, S8500, or S8700-series Media Server. If the primary controller is an S8300, you
should have completed the procedures in Administering an S8300 primary controller
on
page 569.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of required administration, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
In this section, you will use the SAT interface on the primary controller to:
● Assigning Node Names and IP Addresses for the C-LANs and LSPs
● Administering Network Regions
● Assigning LSPs to the Network Regions
● Administering IP Interfaces
● Identifying the Survivable Processor on the primary controller
add survivable-processor sv-mg2-lsp Page 1 of xx
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1