COMMAND LINE INTERFACE
Command Summary
350-8697 DGy Model 201 User Guide 103
. . . . .
RECORDER
. . . . . . . . .
COMMANDS
A summary of DGy 201 recorder commands is listed below. Click the
hyperlink to see a detailed description of the command.
Table 6-9. Recorder Commands Summary
Command Description
Deletes the specified event mark if the event mark is in the clip currently
being played.
This command names (or renames) the specified event mark.
Steps to the next frame of a paused clip
Steps to the previous frame of a paused clip
Displays the timecode and description of the mark number specified.
Lists the timecode and description of all event marks in all clips on both disks.
Creates an event mark within the current clip.
Sends the recorder to the next event mark from the current position and cues
there.
This command pauses the playback or record mode.
Switches the DGy to Playback mode and plays a previously made recording.
Plays the current list of clips to the end and automatically replays the list until
stopped.
Set the playback speed. Applies to forward and reverse play modes.
Sends the recorder to the previous event mark from the current position and
cues there.
This command switches the DGy to Recording mode.
Sets the degree of compression i.e. quality level (Stated in bits/pixel).
Sets the rate at which input frames are compressed and stored to disk.
Enables or disables the disk overwrite feature.
Sends the recorder to the specified event mark and cues there.
This command cancels Play, Pause, and Record recorder functions.
Sets up the DGy to start playback of a specified clip at a pre-determined time.
Sets up the DGy to start recording at a pre-determined time.
Reports the status of any queued synchronized commands.
Cancels all pending queued synchronized commands.
Returns the timecode at the current clip position.
DeleteMARK
EditMARK
FrameNext
FramePrevious
ListMARK
ListEVeryMARK
MARK
NEXTMARK
PAUSE
PLAY
PLAYLOOP
PLAYSPeeD
PREVMARK
RECord
RECordBitRate
RECordFrameRate
RECordLOOP
SeekToMARK
STOP
SYNChronizedPLAY
SYNChronizedRECord
SYNChronizedSTATus
SYNChronizedSTOP
TimeCodeQuery