Filter
Top Products
OPERATIONS
Options Menu
350-8697 DGy Model 201 User Guide 51
. . . . .
SELECTING THE STREAMING SOURCE
• In the Streaming Source section:
~ Click the “Current Input” button to send the encoded
form of the live input signal to the streaming output.
~ Click the “Clip” button to send the selected clip to the
streaming output
• To change the selected clip use the Select
button to open the Clip Browser and navigate to
the clip that you wish to stream (see Clip
Browser Menu on page 39)
SETTING THE STREAM CONNECTION
• In the Set Up section:
~ Set the port number that you choose to stream over.
This is the number of the port that the player will use at
the receiving end of the stream. The default port
number is 8001. It is important that the same port
number is used at the server (DGy 201) end and at the
player end.
Note: The state of the connection is indicated by the
Connected indicator located in the lower portion of the
Streaming Tab. The indicator will be displayed as a
green box if the connection has been opened
successfully, or a red box if the connection was
unsuccessful. If the DGy 201 is unsuccessful at opening
a connection using the specified port number, it will
attempt to use the next available port number. Make
sure that the player is set to use the next highest new
port number. (for example 8002). Note that the port
number 8000 is reserved and should not be used for
this purpose.
STARTING THE STREAM
~ Start the stream using the “Start” button.
STOPPING THE STREAM
~ Stop the stream using the “Stop” button.
Note You must be sure to start sending the stream from
DGy 201 before you receive the stream from the DGy
201 Advanced PC Player software.