Filter
Top Products
OPERATIONS
Options Menu
350-8697 DGy Model 201 User Guide 56
. . . . .
~ Use the Mode drop down menu to select between the
Playback and Free-run modes. In the Free-run mode
the output timing parameters are set by the user. In the
Playback mode the output timing parameters are
automatically loaded to match the format of the clip that
is being played.
~ Use the Test Pattern drop down menu to select a test
pattern to display on the output port. The test pattern
provides a simple way to confirm that the output is
correctly connected to a display device.
~ Use the Gamma spin box to change the gamma of the
playback image for both analog and DVI outputs.
Note: The gamma of the input image recorded to disk is
preserved. The Gamma control does not apply to the
input image.
~ Use the Timing List section of the Output page to set
the output format. To select a new Output format, select
the required format from the drop down Timing list and
click on the Load button. The timing parameters
associated with the format are listed in the Video
Output Timing section of the Output page. These
parameters may be changed by clicking on the Edit
button and making the required changes to the
parameters in the Video Output Timing fields. This
new setting may then be saved to the Timing List by
selecting an unused entry in the list and clicking the
Save button. Unwanted entries to the Timing List can be
deleted by selecting the timing entry that you wish to
delete in the drop down Timing List box, and clicking on
the Delete button.
. . . . . . . . .
SYSTEM TAB
The figure below illustrates the System Tab.
The System Tab is used to view and set communications parameters in
addition to setting the DGy 201’s internal clock.