RGB Spectrum 201 DVR User Manual


 
INTRODUCTION
DGy A/V Inputs and Outputs
350-8697 DGy Model 201 User Guide 4
. . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DGY A/V INPUTS AND OUTPUTS
The DGy 201 includes a comprehensive array of inputs and outputs as
outlined below, enabling you to record and replay low-data-rate signals
— all the way to high resolution graphic displays.
. . . . . . . . .
SYSTEM INPUTS
The following system inputs are provided:
Digital — One digital input is provided (DVI-I integrated
digital/analog connector). With a pixel rate up to 165 MHz, this
input supports a resolution of up to 1600 x 1200 at 60 Hz, or
higher refresh rates at lower resolutions.
RGB — One analog RGB input is provided (DVI-I integrated
digital/analog connector). With a pixel rate up to 330 MHz, this
input supports a resolution of up to 1600 x 1200 at 60 Hz, or
higher refresh rates at lower resolutions.
Loop — Both the analog and digital graphics inputs have an
active loop. The input signal will be output on the loop
connector, provided that the DGy 201 is powered up.
Stereo Audio — One analog stereo input in provided (2 x RCA
phono connectors). Sampling rate may be set to 44.1 kHz,
22.05 kHz or 11.025 kHz.
Composite Video (Optional) - One composite video input with
automatic selection of NTSC or PAL formats.
IRIG Time Code (Optional) - A looping input compatible with
IRIG-B DCLS and 1KHz modulated formats (IRIG B123). Used
to synchronize the system time clock to an external IRIG time
standard. The loop output is used to pass the IRIG-B input
signal to another IRIG compatible device.
. . . . . . . . .
SYSTEM OUTPUTS
The following system outputs are provided:
Digital — One digital output is provided (DVI-I integrated
digital/analog connector), supporting a resolution of 1600 x 1200
at 60Hz.
RGB — One analog RGB output is provided (DVI-I integrated
digital/analog connector).
Stereo Audio — One analog stereo output is provided (2 x RCA
phono connectors).
Pass Through — In record or stop, the DGy 201’s digital or
analog output reflects the audio and video signals presented at
the inputs.
In Appendix A, refer to the “DVI-I Connector” section for complete
wiring details on the DVI-I connector.