Filter
Top Products
INSTALLATION AND SET UP
Installation
350-8697 DGy Model 201 User Guide 17
. . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION
This section provides DGy 201 installation instructions. All connections
are made to the rear of the chassis. Refer to
Figure 2-2 for the name
and location of each rear chassis connector.
Note If the DGy 201 is going to be used in rack, you should
install it in the rack before continuing. Refer to the
“
Rack Mounting” section on page 12 for instructions.
Use the following steps to install the DGy 201:
1. Connect Power — Connect a power cord to the AC Power con-
nector. The DGy 201 is equipped with a universal, 100-240 V,
50-60 Hz power supply.
2. Connect Inputs — Connect the desired computer and / or video
sources if used. Please note:
~ For an analog RGB input, use a standard VGA cable
with a 15-pin male D-sub connector. You will need to
use the supplied DVI-I to analog RGB adapter provided
with the DGy 201. The input connector supports 3, 4 or
5 wire connections. In
Appendix A, refer to the “DVI-I
Connector” section for pinout information.
~ For a digital input, use a standard DVI cable. In
Appendix A, refer to the “DVI-I Connector” section for
pinout information.
3. Connect Graphics Output — Using a DVI-I interconnect cable,
connect the Graphics Output to the desired display device.
The output connector supports both RGB analog and DVI output
signals. With a standard DVI interconnect cable, you can
connect directly to a DVI capable monitor.
To connect to a monitor with an analog RGB input, use an
adapter which converts from the DVI connector directly to a 15
pin D-sub connector. This adapter is provided as a standard
item with your DGy 201. As an alternative, standard cables are
readily available to convert from the DVI connector to either 15-
pin D connectors or BNC connectors.
In Appendix A, refer to the “DVI-I Connector
” section for
detailed wiring instructions for the Graphic Output connector.
4. Connect IRIG In/Out connectors - IRIG time code is an option to
the DGy 201 product. If you have this option connect the output
of your IRIG time code generator to the DGy 201 IRIG input
connector. Connect a cable from the DGy 201 IRIG loop
Note Analog display devices must be able to accept RGB
inputs of at least 15 kHz.