Filter
Top Products
FX Series Programmable Controllers Assigning System Devices 9
9-4
9.2.2 Using the FX
2
-24EI With A F
2
-6A
The F
2
-6A’s operational address is based upon the position of the associated FX
2
-24EI within
the users FX s
y
stem. However, the I/O channel numbers are not affected b
y
this operational
address. The I/O channel will alwa
y
s remain as K000 to K001 and K010 to K013. The dia
g
ram
on the previous pa
g
e shows how movin
g
the position of the FX
2
-24EI used alters the
operational address but NOT the channel number used b
y
the F
2
-6A, see EX. 1A to 1C.
For details on usin
g
the F
2
-6A see the units users manual. Please remember when readin
g
the
manual, that it has been written for use on an F
2
s
y
stem and hence all of the I/O addresses
stated are for such an F
2
setup.
F
2
-6A Channel identification:
• Analo
g
output channels are - K000 and K001 (2 points)
• Analo
g
input channels are - K010, K011, K012 and K013 (4 points)
Applicable FX Applied Instructions:
(Not applicable to FX
2C
Main Processin
g
Units or FX units with CPU’s
g
reater than version
3.06)
• FNC 91, ANRD - used to read the analo
g
data in to the FX
• FNC 92, ANWR - used to write the data from the FX to the F
2
-6A for output
9.2.3 Using the FX
2
-24EI With A F
2
-32RM
The F
2
-32RM’s operational address is based upon the position of the associated FX
2
-24EI
within the users FX s
y
stem. However, the “32RM’s” I/O numbers are will alwa
y
s remain the
same, i.e not be affected b
y
the FX’s operational address. The 32RM’s I/O numbers would
remain as Y0 to Y37, and Bank 0, 1. The dia
g
ram on the previous pa
g
e shows how movin
g
the
position of the FX
2
-24EI used, alters the operational address but NOT the I/O numbers used
b
y
the F
2
-32RM, see EX. 1A to 1C.
For details on usin
g
the F
2
-32RM see the units users manual. Please remember when readin
g
the manual, that it has been written for use on an F
2
s
y
stem and hence all of the I/O addresses
stated are for such an F
2
setup.
Applicable FX Applied Instructions:
(applicable to all FX and FX2C Main Processin
g
Units)
• FNC 93, RMST - used to output a start code from the FX to the F
2
-32RM
• FNC 94, RMWR - used to disable outputs on the F
2
-32RM
• FNC 95, RMRD - used to read the ON/OFF status of the F
2
-32RM
• FNC 96, RMMN - used to monitor speed and current position of the F
2
-32RM