Filter
Top Products
62
Continued
Programming remote control signals for a key or button – Learning function (LEARN)
z Tips
• Operate the key or button that learned the signal, and check if the AV component
functions properly. If the AV component does not function properly, perform learning of
a remote control signal again.
•You cannot teach a remote control signal to the Direct Access buttons or Component
keys directly. To use the learned signal with these buttons/keys, first teach function keys
in the component, and then program the action of the learned key/button as a macro for
the Direct Access button or Component key. For details, see “Programming a series of
actions (macro) for a key/button” (page 115).
For accurate learning
• Do not move the remote control units during the learning procedure.
• Do not disconnect or connect the AC power adaptor or the USB cable while
learning. This may cause an incorrect learning procedure. It is recommended
to connect the AC power adaptor before learning.
•Press and hold down the button of the remote control whose signal you want
to teach until a beep sounds.
• Decide the position of two remote control units or the distance between them
according to the position of the infrared ray emitter.
• When you teach signals of an interactive signal exchange system remote
control unit (supplied with some Sony tuners, amplifiers and receivers) to the
Remote Commander, the response signal of the main unit may interfere with
learning of the Remote Commander. In this case, move to a place where the
signals will not reach the main unit (e.g. other rooms, etc.).