Filter
Top Products
142 PARAGON II USER GUIDE
Configuring AUATC
Press Alt + F2 to activate the Setup Screen, where you can select your desired serial-
communication parameters (baud rate, etc.) and local/remote output. The initial parameters will
always start at their factory defaults, so make sure that the serial port or device to which AUATC
is attached is temporarily configured for 9600 bps, 8 data bits, no parity, and 1 stop bit. (If the
port or device cannot support all of these settings, you must temporarily attach one that can.) Also,
if you want to perform initial configuration with a “local user station,” it must consist of a PS/2
keyboard and a VGA monitor.
Available data-rate (“Baud Rate”) settings are 2400, 4800, 9600, and 19,200 bps. You can select
even, odd, or no (“None”) parity; 7 or 8 data bits; and 1 or 2 stop bits (but 7 data bits requires 2
stop bits). The terminal type is fixed at VT100.
For local/remote connection, choose CAT5&LOCAL if you connect the AUATC both to a local
monitor via the VGA HD15 connector and to Raritan’s Paragon switch via the Cat5 port (RJ45);
choose LOCAL if the unit is connected to a local monitor only.
Figure 113 Setup Communication Screen