Filter
Top Products
CHAPTER 2: INSTALLATION 21
Several administrative functions can be performed on the Function Menu on the Paragon switch’s
front panel LCD.
Display Ver./SN
Test User UST1
Test Chan. UKVM
Test Stack Unit
Stacking Support
Set LCD Contrast
Re-Configure
Set IP Address
Reset Unit
Figure 11 LCD Functions
Selecting a Function:
Press the FUNC button on the front panel of the Paragon switch to enter Function Menu mode
and use the U and V buttons to scroll through the Function List. Press the ENT button on the
front panel to select one displayed function and use the instructions below for each specified
function. Press the ESC button on the front panel at any time to return to Normal Display.
Figure 12 Function Selection
1. Display Ver./SN (Firmware Version and Serial Number): Displays current version of
firmware, the firmware loader, the unit’s serial number, and the field programmable gate
array (FPGA).
Figure 13 Display Ver. and SN
2. Test User UST1 (User Station): Used by an administrator to check if user stations (UST1s)
are functioning properly. Press the U or V button to change user port number. Display will
read “OK”, “None”, or “Failed.” Press ESC to return to normal display.
If a “failed” condition is detected, make sure the Category 5e UTP cable is installed properly
and secured, or try using another user station to see if the user station (UST) under test has
become defective.
Figure 14 User Station Test
3. Test Channel UKVM (CIM UKVM): Used by an administrator to check if a CIM is
functioning properly. Press the U or V button to change channel number. Display will read
“OK”, “None”, or “Failed.” Press ESC to return to normal display.