Filter
Top Products
CHAPTER 2: INSTALLATION 17
Chapter 2: Installation
Important: The Paragon and all devices you want to attach to it must be unplugged and
powered OFF prior to installation.
Basic Installation
Figure 5 Installation Diagram
A
Stacking Unit (optional)
B
Main Unit
C
User Station
D
Computer Interface Module (CIM)
Note: The above images are for illustration only and may not be the exact representation of the
Paragon components you purchased.
The steps below correspond to the numbers in the above diagram.
1. Connect the power cord to the Main Unit.
2. (Optional) Connect a Stacking Unit if it is needed.
− Connect the power cord to the Stacking Unit.
− Connect one end of a stacking cable to the "Expansion Port Out" on the back of the
Stacking Unit. Connect the other end of the cable to the "Expansion Port" on the Main
Unit.
Note: For P2-UMT1664M and P2-UMT1664S, you must use two stacking cables. For
detailed instructions, see Installing the Paragon P2-UMT1664S Stacking Unit later in
this chapter.