Filter
Top Products
18 PARAGON II USER GUIDE
− Power on all switching units.
− On the front panel of the Main Unit:
Press the FUNC button and then use the U and V buttons to select "Stacking
Support." Press the ENT button to confirm the selection.
Use the U and V buttons to set the total number of Stacking Units desired (3
maximum for P2-UMT832M or 1 maximum for P2-UMT1664M). Press the ENT
button to save the setting.
− On the front panel of the Stacking Unit:
Press the FUNC button and then use the U and V buttons to select "Set Stack ID."
Press the ENT button to confirm the selection.
Use the U and V buttons to assign the Stacking Unit ID. (Each Stacking Unit for
P2-UMT832M MUST HAVE A UNIQUE ID [1-3].) Press the ENT button to save
the setting.
− Power OFF all switching units.
− Power ON the Stacking unit. (This must be done before powering on the Main Unit.)
3. Power on the Main Unit.
4. Connect one end of a Category 5e UTP cable to User Port #1 on the back of the Main Unit.
Connect the other end of the cable to the “Cat5 Port” or “Paragon Port” on the back of the
user station.
5. Connect a power cord to the user station and power it on.
6. Connect a PS/2 or USB keyboard, mouse, and a VGA monitor to the user station. Power on
the monitor.
7. Connect one end of a Category 5e UTP cable to Channel Port #1 on the back of the Main
Unit (or Stacking Unit, if attached). Connect the other end of the cable to the RJ45 port on a
Computer Interface Module (P2CIM).
8. Connect P2CIM to a server’s keyboard, video, and mouse ports.
9. Power on the server.
10. Repeat steps 4 through 9 for all other servers and user stations you want to attach.
Note: Although users and servers can be located up to 1000 feet (304 m) apart, for optimal video
quality, limit the cable length between the Main Unit and CIM to less than 100 feet (30.5 m). For
good video quality, limit the cable length to less than 500 feet (152 m).
Initial Administrative Verification
To verify that an attached server can be viewed and controlled through the Paragon system:
1. When you first power on the Paragon Main Unit, an attached user station, and the user
station’s attached monitor; the Login screen appears. Type admin in the User Name field
and press Enter. Type raritan (all lowercase) in the Password field and press Enter.
Note: The factory-default user names for regular users are user01 through up to user15
(depending on the model of your Main Unit), and for the administrator is admin. User names
are not case-sensitive. By default, a password is required only for the admin user, and that
password is raritan. Note that passwords are case-sensitive.