Filter
Top Products
98
Chapter 6
Messages & Setup
4. Enter a code. Use the number buttons on the remote control to enter a four-digit code
(starting with the first code in the list on the screen). After you press the fourth digit of
the code, the red light on the end of the remote control should flash. If it doesn’t, try
the next code.
5. Test the code. Point the remote towards the TV and test the button:
If pressing the button works (e.g., turns the TV or A/V receiver off, or changes the TV
input), the code is correct. If it does not work, repeat steps 3 and 4 using the next code
on the list. If none of the codes works, perform a code search (see below).
Performing a Code Search
If none of the codes listed allows you to control your device, a code search may detect the
correct code. Performing a code search can take up to 20 minutes.
1. Prepare the remote control. Point the remote away from your Recorder and cover the
front end with your hand.
Refer to the table below and determine which two buttons to press to prepare the
remote. Press and hold the buttons simultaneously for about 5 seconds (until the red
light at the end of the remote lights up and stays lit when you release the buttons).
To Test the:
TV power, volume,
and mute
TV input A/V receiver power,
volume, and mute
A/V receiver volume
and mute only
Press the:
TV POWER button TV INPUT button TV POWER button MUTE button
To Control:
TV power, volume,
and mute
TV input A/V receiver power,
volume, and mute
A/V receiver volume
and mute only
Press the:
TV POWER and
TiVo buttons
TV INPUT and
TiVo buttons
TV POWER and
TiVo buttons
MUTE and
TiVo buttons
TiVo Central Messages & Setup Settings Remote Control & Recorder Front