Filter
Top Products
101
Remote Control & Recorder Front
6
Resetting the Programmable Buttons
If you make a mistake, or are having difficulty, you can reset the programmable buttons
(TV POWER, VOLUME, MUTE, TV INPUT, and the DVR SWITCH). All the remote's
buttons will return to the unprogrammed state of a new remote.
1. Prepare the remote control. Point the remote away from your Recorder and cover the
front end with your hand.
Press and hold the TV POWER button and TiVo button simultaneously until the red
light at the end of the remote control comes on, remains steady, then stays on when
you release the buttons.
2. Press THUMBS DOWN™ three times, then press ENTER. (To cancel, press CLEAR
before you press ENTER.)
Front Panel Lights
You can change the settings of the lights on the Recorder’s front panel.
Recorder Front - Clock Light. You don’t have to set the clock on the front of the
Recorder—the TiVo service sets it for you. (No more blinking “12:00”!). This setting lets
you dim or turn off the clock.
Recorder Front - LED Lights. The Recorder has LED (light emitting diode) lights on its
front panel to indicate when it is receiving power and when it is recording a program. You
can choose to turn off these lights.
Even if you choose to turn off the front panel lights, one of the LEDs on the front panel
will flash briefly when a button on the remote is pressed. This indicates that the Recorder
is receiving a signal from the remote.
TiVo Central Messages & Setup Settings Remote Control & Recorder Front