Filter
Top Products
232 C2630M-C (7/09)
e. Click No to the Append option.
Figure 176. Loading a Mapping Sequence
Modifying a Sequence Instance in the List
To modify a sequence instance in the list:
1. On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.
2. Click the Ext. Monitor button . The External Output page is displayed.
3. In the Manual Camera Mapping Mode section, do the following:
a. Click the button (if it is not selected) to select the Manual Camera Mapping mode.
b. Click one of the sequence instances from the list.
c. Select a screen division.
d. Drag cameras from the Site Tree onto each view panel until cameras have been assigned to all panels.
e. From the Min and Sec drop-down boxes, select the amount of time the sequence instance will remain on the monitor.
f. Click Modify.
g. Click Save.
The Save dialog box open.
4. Select an existing profile or enter a new profile name under which to save the sequence list.
5. Click OK.
6. Click Apply.
3c
3a
3a
3
d
3
b