Filter
Top Products
234 C2630M-C (7/09)
7. Click Apply at the bottom of the External Monitor page.
Figure 178. Delete a Mapping Sequence
Appending an Existing Sequence List
To append an existing sequence list to the current list:
1. On the DX8100 toolbar, click the Setup button . The Setup dialog box opens to the Camera page.
2. Click the Ext. Monitor button . The External Output page is displayed.
3. Click Load. The “Load profile” dialog box opens.
4. Select a profile.
5. Click OK.
The “Append to list” dialog box opens.
6. Click Yes to add the new sequences to the existing list.
7. To add, delete, or modify sequence instances, follow the directions in the sections above.
8. Click Save.
9. Select an existing profile or enter a new profile name to save the sequence list.
10. Click OK.
11. Click Apply in the Sequence Table section.
12. Click Apply.
ᕦ
3
b
3c
3a
3a