Filter
Top Products
62 C2630M-C (7/09)
CONFIGURING PRESET TOURS
A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX8100 Series HVR can store up to four preset
tours. While four tours can be programmed, only one tour can be activated at a time. A preset tour will operate continuously until another PTZ
control action is performed. At least one PTZ preset must be set in order to create a preset tour.
The PTZ controls are hidden in the extended view mode. In this case, select the standard view mode to display the PTZ controls.
To switch between the standard and extended view mode:
• From the DX8100 menu bar, choose View > Extended View.
This section describes how to configure preset tours and includes the following topics:
• Programming a Preset Tour
• Activating a Preset Tour on page 65
• Deactivating a Preset Tour on page 65
PROGRAMMING A PRESET TOUR
This section describes how to program a preset tour and includes the following topics:
• Accessing a Preset Tour Group
• Adding Presets to a Tour on page 63
• Deleting Presets from a Tour on page 64
Accessing a Preset Tour Group
To access the “Preset tour group” dialog box:
1. On the DX8100 toolbar, click the Live button .
2. On the PTZ keypad, click the Set button and then click the Pgm button . The “Preset tour group” dialog box opens.
3. Select the preset tour (1-4) that you want to program from the drop-down box.
4. Do one of the following:
• To add presets to a tour, refer to Adding Presets to a Tour on page 63.
• To delete presets from a tour, refer to Deleting Presets from a Tour on page 64.
Figure 33. Preset Tour Dialog Box
ᕣ