Filter
Top Products
100 English
RECORD SET2
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
3 Turn the jog dial to select “2.RECORD
SET” and then turn the shuttle dial
clockwise.
The <RECORD SET> screen is displayed.
4 Turn the jog dial to select “7.ALARM
REC MODE SET” and then turn the
shuttle dial clockwise.
The <ALARM REC MODE SET> screen is displayed.
5 Turn the jog dial to select “MOTION
SENSOR” and then turn the shuttle dial
clockwise.
6 Press a [CAMERA SELECT] button.
Press the button of the number of the camera for which
motion sensors are to be set up.
-
On the DSR-5009P, press the [CAMERA SELECT] 1-9
button.
7 Turn the jog dial to move the cursor
(blue) to the position where a sensor is
to be set and then turn the shuttle dial
clockwise.
Turn the jog dial while pressing the [FUNC.] button to move
the cursor (blue) vertically.
Cursor can be moved up and down using the jog dial if a mark
indicating such actions is displayed in the upper right of the
screen.
8 Turn the jog dial to select “A” or “B”.
9 Turn the shuttle dial clockwise twice.
The change is defined.
10 Use the same procedure to set other
sensor positions.
<ALARM REC MODE SET>
ALARM RECORDING : OFF
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ***
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : SENSOR
MOTION SENSOR ->
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : SENSOR
MOTION SENSOR ->
CH01 T-1 LEVEL : OFF MODE : A
The <MOTION SENSOR>
screen is displayed.
The cursor (blue) is displayed
at the top left position.
Cursor can be moved to the
left and right using the jog
dial if a mark indicating such
actions is displayed in the
upper right of the screen.
CH01 T-1 LEVEL : OFF MODE : A
FUNC.
CH01 T-1 LEVEL : OFF MODE : A
A
“A” or “B” : Sensor set
“-” : No sensor
CH01 T-1 LEVEL : OFF MODE : A
A
e00_l8hbd_xe_7.book Page 100 Tuesday, April 5, 2005 11:41 AM