Filter
Top Products
120 English
GENERAL SET3
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
Use the following procedure to make menu settings for the
digital video recorder and to monitor video from a PC via a
network (LAN).
A LAN cable must be connected to the LAN terminal on the
rear panel before proceeding.
z Connecting to a PC directly
(without using a switch)
z Connecting to an intranet
(using a switch)
The setting is necessary for controlling the DVR from a PC on
a network.
Contact the network administrator for more details on setting
values.
z DHCP
Set whether the IP address is automatically acquired from the
DHCP server or manually set. Set “ON” when automatically
acquiring an IP address from an Internet service provider or
from a DHCP server on a LAN, and set “OFF” when using a
fixed IP address.
z IP ADDRESS
Select “OFF” for “DHCP” to set. Generally, a private IP
address is used when a fixed IP address is set in a LAN
(example: 192.168.0.0 – 192.168.255.255).
Be sure not to duplicate IP addresses from other devices.
z SUBNET MASK
Select “OFF” for “DHCP” to set. The same value is set
throughout the LAN.
z GATEWAY
Select “OFF” for “DHCP” to set. When connecting from a LAN
to a WAN or other differing network, specify the device IP
address (on the LAN side).
z HTTP PORT
Sets open port. Default value is “80”.
z NETWORK SPEED
Sets restrictions for traffic in the LAN. Normally, set it to “NO
LIMIT”.
z DNS SET
Settings relating to the Domain Name Server are performed in
another screen.
z DNS SERVER
Set whether the DNS server IP address is automatically
acquired or manually set. Generally this setting is “AUTO”
when “ON” is selected for “DHCP”. When the DNS server
address is specified by a network administrator or Internet
service provider, select “MANUAL” and set the following
items, “PRIMARY” and “SECONDARY”.
z PRIMARY
z SECONDARY
Set when “DNS SERVER” is set to “MANUAL”. Set the
DNS server address received from the network
administrator or Internet service provider.
Network settings
Making network connections
MAIN
1 16
LAN
2
1
3
4
Monitor
(sold separately)
A crossed-type LAN cable must
be used here. (10BASE-T/
100BASE-TX Category 5)
1 - 16
PC
PC
MAIN
1 16
LAN
2
1
3
4
Monitor
(sold separately)
Switch
Switch
A straight-type LAN cable must
be used here. (10BASE-T/
100BASE-TX Category 5)
Intranet
PC
1 - 16
PC
Making network settings
e00_l8hbd_xe_7.book Page 120 Tuesday, April 5, 2005 11:41 AM