Filter
Top Products
SEARCHING FOR RECORDED VIDEO3
English 173
Use the following procedure to detect variations from
recorded images, using the motion sensor, as a result of the
presence of an intruder or the like, and to play back the
corresponding images.
(1) SEARCH FROM
Recording area to be used for motion detection searching
(2) CHANNEL
Channel or camera number to be used for motion detection
searching
(3) START/END
Date and time of the start and end of the area for motion
detection searching
(4) [SET] button
Detection condition settings
(5) Message box
Displays the results of searching for motion detection images.
(6) MOTION SENSOR SET
Screen for making motion sensor settings
(7) MOTION SENSOR LEVEL
Motion sensor sensitivity setting: OFF or 1 through 10
(Lower numbers correspond to higher levels of sensitivity.)
(8) [PREVIEW] button
Displays a preview of the motion detection image.
1 Click “6. MOTION DETECTION
SEARCH” on the “SEARCH” screen.
The “MOTION DETECTION SEARCH” screen is displayed.
2 Specify the search area from the
“SEARCH FROM” pull-down menu.
[Settings] ( indicates default setting)
*1 “ARCHIVE” can only be selected when “MODE” in
“ARCHIVE AREA” in the <RECORDING CONDITIONS
SET> screen is set to “AUTO ALARM COPY”. (JP.81)
3 Specify the camera number for
detection from the “CHANNEL” pull-
down menu.
4 Click [SET].
The date and time of the start and end of recording of motion
detection images are displayed in “START” and “END”
respectively.
z Use “START” and “END” to refine the search range by
making date and time settings.
z The search results are displayed in a message box when
[SET] is clicked.
5 Set motion sensor detection conditions.
z Motion sensor positions
The motion sensor setting screen displays an 8 x 10
(height x width) grid of sensors. When one of these
sensors is clicked, the corresponding sensor setting mark
changes to red. If the same location in the grid is clicked
again, the motion sensor is deselected.
z Motion sensor sensitivity
Select the sensitivity from the pull-down menu. Lower
numbers correspond to higher levels of sensitivity.
6 Click [PREVIEW].
A search is performed within the specified area for images in
which the motion sensor detected motion, and these images
are then listed in recording order on the preview screen.
7 Click the preview screen to play back
the image.
Full-screen playback starts.
6. MOTION DETECTION SEARCH
When searching “SEARCHING”
When motion-detection
images exist
“FOUND !”
When motion-detection
images do not exist
“IMAGES NOT FOUND !”
A
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
BCDEFGH I J
ABCDEFGH I J
ABCDEFGH I
J
ABCDEFGH I J
MOTION SENSOR SET
MOTION SENSOR LEVEL:
OFF
PREVIEW
PLEASE CLICK THE IMAGE TO PLAY.
FOUND !
01 -- :01 00 40
2005
01 -- :09 12 40
SET
2005
--
MOTION DETECTION SEARCH
SEARCH FROM :
CHANNEL
:
START
:
END
:
ALARM
(1)
(2)
(3)
(5)
(4)
(7) (8)
(6)
Setting Description
ALARM
Searches only for alarm recording
images.
NORMAL
Searches only for normal
recording images.
ALARM AND NORMAL
Searches for alarm recording and
normal recording images.
ARCHIVE
*1
Searches only for archive images.
e00_l8hbd_xe_7.book Page 173 Tuesday, April 5, 2005 11:41 AM