Filter
Top Products
96 English
RECORD SET2
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
15 Turn the jog dial to select the
“DURATION” setting and then turn the
shuttle dial clockwise.
The cursor moves to “PRE-ALARM RECORDING”.
[Settings] ( indicates default setting)
16 Press the [EXIT/OSD] button.
The setting is completed and the display returns to the normal
screen.
“ALARM” appears in the operation display.
When an alarm occurs, the number of alarms is displayed.
z If a new alarm from a different channel occurs during alarm
recording, the alarm number in the top-right corner is
incremented as if two alarms occurred. However, in cases
where alarms occur consecutively on the same channel,
alarm retrigger settings (JP.98) can be used to ensure that
these are counted as only one alarm.
Use the following procedure to set the recording rate and
time.
z Settings cannot be made for “PRE-ALARM RECORDING”
when “ALARM REC” is set to “OFF”.
1 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
2 Turn the jog dial to select “2.RECORD
SET” and then turn the shuttle dial
clockwise.
3 Turn the jog dial to select “7.ALARM
REC MODE SET” and then turn the
shuttle dial clockwise.
The <ALARM REC MODE SET> screen is displayed.
4 Turn the jog dial to select “PRE-ALARM
RECORDING” and then turn the shuttle
dial clockwise.
“OFF” flashes.
Setting Description
5SEC, 10SEC, 20SEC,
40SEC, 1MIN, 2MIN, 3MIN,
4MIN, 5MIN, 10MIN, 15MIN
Records for the set duration for
each alarm.
CC
Records while an alarm is
activated.
Recording continues for five
seconds even if entry is less than
five seconds.
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : ON
ALARM INTERLEAVE : ONLY
REC RATE:A12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : ALARM
MOTION SENSOR ->
01-01-05 00:00:00 REC REPEAT EN A ALARM 0000001
02
Number of alarms
“ALARM” display
EXIT/OSD
To set pre-alarm recording
MENU
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : ALARM
MOTION SENSOR ->
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : ALARM
MOTION SENSOR ->
e00_l8hbd_xe_7.book Page 96 Tuesday, April 5, 2005 11:41 AM