Filter
Top Products
OPERATION PANEL FUNCTIONS AND RESTRICTIONS3
English 161
4. Menu set
Sets the camera internal menu item setting values.
5. [MENU]
Displays camera internal menu screen.
6. Control speed
Adjusts the operation speed for Pan and Tilt.
Sets a level between 1 and 7. Higher values correspond
to faster operation speed.
7. [ZOOM]
Activates zoom mode. (“ZOOM” turns green)
Use -/+ to zoom.
8. [FOCUS]
Activates focus adjust mode. (“FOCUS” turns green)
Adjust focus with -/+.
9. [IRIS]
Activates IRIS adjust mode. (“IRIS” turns green)
Adjust IRIS with -/+.
10. -/+
Use when zooming, adjusting focus, and adjusting IRIS.
11. [AF]
Use auto-focus.
12. [SEQ]
Starts automatic camera selection. Press a different
operation button to switch to that operation.
13. [PAN]
Starts automatic panning. Press a different operation
button to switch to that operation.
14. [TOUR]
Starts the TOUR saved on the camera. Press a different
operation button to switch to that operation.
15. Preset access
Move camera into position set with preset number.
For preset numbers after 9, select from the drop-down list
and click [GO].
16. Preset register
Select a preset number from the drop-down list and click
Menu set to register the current camera position.
17. Record (LV3, LV4)
This button starts normal recording.
18. Record stop (LV3, LV4)
This button stops normal recording.
19. Timer (LV3, LV4)
This button activates timer standby mode when clicked
while recording is stopped. If clicked in Timer Standby
mode, it deactivates this mode.
20. Disconnect (LV1, 2, 3, 4)
This button disconnects the PC from the network and
switches control rights to the unit.
z When pan/tilt is pressed during automatic panning,
automatic camera selection or TOUR, manual pan/tilt
mode is entered and all automatic modes are cancelled.
3 Click [CAMERA CONTROL].
Camera operation panel changes to Normal operation panel.
Finishing dome camera operation
e00_l8hbd_xe_7.book Page 161 Tuesday, April 5, 2005 11:41 AM