Filter
Top Products
16 English
INSTALLATION AND CONNECTIONS3
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
Connect to a PC for control of the digital video recorder over a
network with a switch or connect to the Internet.
To enable control of the digital video recorder over a network,
connect to the switch via Ethernet cable or make a similar
connection.
Use a straight type Ethernet cable.
Connect to the Internet via a router or similar device.
When connecting to a router, use a straight type Ethernet
cable.
To connect to an ADSL modem and other devices, be sure to
read the instruction manuals for each connected device.
Connect an amplifier to use a microphone or external
speakers with the digital video recorder. AUDIO 1 IN terminal
and AUDIO 2 IN terminal can be used together to record and
play back audio from two locations.
z The input audio channel connected to the AUDIO IN
terminal on the rear panel can be switched with the
[AUDIO] button. Each time this button is pressed, the
channel changes in the following order: 1+2, OFF, 1, 2.
When using external alarms (i.e., intruder sensors), connect
external switches to the ALARM IN terminals.
Only terminals 1 to 9 are available on the DSR-5009P.
* Wrap the Alarm input cable and the Sensor alarm output
cable once around the core clamp (large) before attaching it.
Connecting a LAN terminal
LAN connection
Internet connection
LAN
Switch
Ethernet cable
(straight type cable)
PC
LAN
Internet
Router, ADSL
modem, etc.
Ethernet cable
(straight type cable)
Connecting an amplifier
Connecting alarm input terminals
1-AUDIO-2
AUDIO OUT
IN
Audio input
terminal
Audio
output terminal
Amplifier
(sold separately)
1
16
Connect external
switches to ALARM IN
terminals.
*
e00_l8hbd_xe_7.book Page 16 Tuesday, April 5, 2005 11:41 AM