Filter
Top Products
English 13
3 INSTALLATION AND CONNECTIONS
This section describes how to connect the digital video recorder to video cameras and other devices. Be sure to read the instruction
manuals for each connected device.
z Improper connections may result in malfunction or smoke emission.
z A separate power supply is required for operation of each camera.
z Manage power for all expansion units with a single power source. Otherwise, data may be lost.
DSR-5016P
Only nine cameras can be connected to the DSR-5009P.
The following diagram shows the connections for cameras, monitors, a microphone, a PC and a system controller.
The RS-232C terminal is used to connect to a PC or a phone
line for use with a modem. Perform the settings in the <RS-
232C/RS-485 SET> screen. (JP.115)
RS-232C Pin locations
Basic connections
EXTERNAL STRAGE UNIT
MONITOR OUT
SCSI
MAIN
USB
LAN
TERMINATE
RS-485
OFF ON
MON2 S-VIDEO 1-AUDIO-2
AUDIO OUT
RS-232C
ALARM IN
AC IN
DO NOT CONNECT TO PHONE LINE
MIC IN
C
L
OCK IN
C
L
OCK OUT
EXT TIMER IN
ALAR
M
OUT
ALARM
RESET
NON RE
C
O
UT
W
ARNING O
UT
F
ULL
REMOTE
CONTROL
C
123456789
10 11 12 13 14 15 16
C
CR1R2
1
IN
OUT
ALL
RESET
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
IN
0201
0403
1234
SENSOR
ALARM OUT
A
2ND
RS-485/422
EXCEPT SANYO SSP
B
A SANYO SSP B
RS-485
AR
CHIVE
FULL
Video input
terminal
PC
(commercially-available)
Monitor
(sold separately)
Video input
terminal
Monitor 2
(sold separately)
120 V – 240 V AC
(50/60 Hz)
* If monitor 2 is not synchronized
with the connected cameras,
vertical picture instability may
occur upon the switching of
camera video.
Cameras
(sold separately)
1 - 16
Microphone
(commercially-
available)
System controller
(sold separately)
The RS-485 connector is
connected to A or B according to
the type of cable.
HDD expansion unit
(sold separately)
1 - 4
*1
*2
*1 Wrap the LAN cable once around the core clamp (large) before attaching it.
*2 Wrap the RS-485 cable twice around the core clamp (small) before attaching it.
*3 Wrap the Main Monitor output cable once around the core clamp (large) before attaching it.
*4 Wrap the S-VIDEO output cable once around the core clamp (small) before attaching it.
*3
*4
Connecting the RS-232C terminal
Pin
number
Signal Operation Signal direction
1 DCD Carrier Detect
From PC to digital video
recorder
2 RXD Receive Data
From PC to digital video
recorder
9876
54321
3 TXD Transmit Data
From digital video
recorder to PC
4DTR –
From digital video
recorder to PC
5 GND Ground –
6DSR –
From PC to digital video
recorder
7RTS
Request to
Send
From digital video
recorder to PC
8 CTS Clear to Send
From PC to digital video
recorder
9 RI Ring Indicator
From PC to digital video
recorder
Pin
number
Signal Operation Signal direction
e05_l8hbd_xe_7.fm Page 13 Tuesday, April 5, 2005 12:12 PM