Sanyo DSR-5009P DVR User Manual


 
72 English
RECORD SET2
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
8. ALARM OPERATION SET (JP.102)
Makes settings for
operation and display upon
detecting an alarm.
Use the following procedure to make simple recording
settings. Two different setting methods may be used -- one
based on recording days, the other based on recording rate.
z When easy setup settings and individual settings are both
set, the most recent settings override previous settings.
z Easy setup settings are cancelled as a result of the
following operations.
(1) When the number of cameras detected using “CAMERA
DETECT” differs from the number of cameras previously
set in the digital video recorder.
(2) When menu settings are loaded from a CompactFlash
card.
(3) When a new easy setup setting is performed.
(4) When setting values are changed for normal recording or
timer recording.
(5) When the recording area is changed using the
<RECORDING AREA SET> screen.
(6) When the mirroring setting is changed using the <HDD
SET> screen.
(7) When replacing or expanding the hard disk.
1 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
2 Turn the jog dial to select “2.RECORD
SET” and then turn the shuttle dial
clockwise.
The <RECORD SET> screen is displayed.
3 Turn the jog dial to select “1.NORMAL
REC EASY SET” and then turn the
shuttle dial clockwise.
The <NORMAL REC EASY SET> screen is displayed.
4 Turn the jog dial to select “RECORDING
DURATION BASE” and then turn the
shuttle dial clockwise.
The <RECORDING DURATION BASE> screen is displayed.
The number of detected cameras is indicated by “NUMBER
OF CAMERAS”.
z Confirm that the number of cameras connected to the
digital video recorder is the same as the number of
displayed recording cameras. If this is not the case, check
the wiring between cameras and the digital video recorder
and then perform “CAMERA DETECT”. (JP.64)
5 Turn the shuttle dial clockwise.
“1” flashes.
Normal recording easy setup
Setting based on recording days
<ALARM OPERATION SET>
ALARM RETRIGGER : OFF
MAIN MON. DISPLAY : FULL
ALARM PRIORITY : LAST
MON.2 DISPLAY : NC
MENU
<NORMAL REC EASY SET>
RECORDING DURATION BASE ->
REC RATE BASE ->
CAUTION !
CONNECT CAMERA AND SET TIME
BEFORE SETUP
<RECORDING DURATION BASE>
RECORDING DURATION : -- DAYS
TIMER RECORDING(DLY) : OFF
START --:-- STOP --:--
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
NUMBER OF CAMERAS : 2
REC RATE : ---- FPS/CAM
<RECORDING DURATION BASE>
RECORDING DURATION : 1 DAYS
TIMER RECORDING(DLY) : OFF
START --:-- STOP --:--
PICTURE QUALITY : ENHANCED
AUDIO RECORDING : OFF
NUMBER OF CAMERAS : 2
REC RATE : 30.000FPS/CAM
e00_l8hbd_xe_7.book Page 72 Tuesday, April 5, 2005 11:41 AM