Filter
Top Products
English 29
3 RECORDING
Use the following procedure to record monitored video.
z Be sure to set the time when using the digital video
recorder for the first time. Recording is not possible until
the time is set. (JP.20)
1 Press the [REC/STOP] button.
The REC/STOP indicator lights up, “REC” (i.e., the recording
symbol) appears in the operation display and recording starts.
z When recording for the first time, the default settings are
used. (JP.83)
z When “OVERWRITE” on the <RECORDING
CONDITIONS SET> screen is set to “OFF” and the space
remaining in the recording area becomes insufficient, the
FULL indicator begins to flash. If recording is continued
beyond this point, the recording area becomes full and
recording stops. Perform AREA FULL RESET to enable
recording. (JP.79)
z Playback is possible even while recording. (JP.18)
2 Press and hold the [REC/STOP] button
for approximately 3 seconds to end
normal recording.
“REC” disappears from the operation display and recording
ends.
Use the following procedure to record monitored video for a
preset length of time.
z Be sure to set the time when using the digital video
recorder for the first time. Recording is not possible until
the time is set. (JP.20)
1 Set timer recording. (JP.87)
2 Press the [TIMER] button.
The TIMER indicator lights up and the digital video recorder
enters timer recording standby mode.
z At the time specified for the start of timer recording, the
REC/STOP indicator lights up, “REC” (i.e., the recording
symbol) appears in the operation display and recording
starts.
z At the time specified for the end of timer recording, the
REC/STOP indicator turns off and recording ends. The
TIMER indicator remains lit. If the [TIMER] button is
pressed, the TIMER indicator turns off.
z When “OVERWRITE” on the <RECORDING
CONDITIONS SET> screen is set to “OFF” and the space
remaining in the recording area becomes insufficient, the
FULL indicator begins to flash. If recording is continued
beyond this point, the recording area becomes full and
recording stops. Perform AREA FULL RESET to enable
recording. (JP.79)
z Playback is possible even while recording.
3 Press the [TIMER] button to end timer
recording before the end time.
The TIMER indicator turns off and recording ends.
[REC/STOP] button [TIMER] button
FULL indicator
Normal recording
02
0
01-01-05 00:00:00 REC REPEAT EN A
Recording symbol
REC/STOP
REC/STOP
Timer recording
02
0
01-01-05 00:00:00 EN A
TIMER
TIMER
e00_l8hbd_xe_7.book Page 29 Tuesday, April 5, 2005 11:41 AM