Filter
Top Products
102 English
RECORD SET2
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
16 Turn the jog dial to select the “MODE”
setting and then turn the shuttle dial
clockwise.
The cursor moves to the top left sensor.
[Settings] ( indicates default setting)
17 Use the same procedure to set “LEVEL”
and “MODE” for “T-2” through “T-4”.
z Motion sensor positions are common for “T-1” through “T-
4” and different settings cannot be made.
18 Turn the shuttle dial counter-clockwise.
Motion sensor settings are confirmed and the <ALARM REC
MODE SET> screen is displayed once again.
To stop motion sensor recording
Press the [MENU] button and select “2.RECORD SET”, “7.
ALARM REC MODE SET”, and “MOTION SENSOR” and
when the motion sensor settings screen appears set “LEVEL”
to “OFF”.
z The sensitivity level can be checked on the setting screen.
When motion is detected, the sensor color changes from
green to red, and a buzzer is sounded. When “C” is
selected in “MODE” the buzzer is sounded.
If detection is too sensitive, an alarm can be triggered even
by slight changes in lighting; accordingly, the sensitivity
level should be set to match the camera location.
z The period for “T-1” through “T-4” as set in step 12
changes to that of “TIME PERIOD A” or “TIME PERIOD B”
on the <TIME PERIOD SET> screen.
Use the following procedure to display the main monitor and
monitor 2 when an alarm is detected.
1 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
2 Turn the jog dial to select “2.RECORD
SET” and then turn the shuttle dial
clockwise.
The <RECORD SET> screen is displayed.
Setting Description
A
The motion sensor alarm is triggered when a
moving object is detected in A.
B
The motion sensor alarm is triggered when a
moving object is detected in B.
A AND B
The motion sensor alarm is triggered when a
moving object is detected by a sensor in both A
and B.
A AND NB
By setting A to important points (moving objects)
and B to non-moving points, the motion sensor
alarm is not triggered when the overall screen
brightness changes. The motion sensor alarm
only activates when A experiences a change
and B does not.
A TO B
The motion sensor alarm is triggered when an
object is detected moving from A to B. (within 2
seconds from A to B)
B TO A
The motion sensor alarm is triggered when an
object is detected moving from B to A. (within 2
seconds from B to A)
C
A motion sensor alarm is triggered when the
entire image changes uniformly. In this way,
sprays and other similar measures can be
protected against. (No sensor settings are
needed for this mode.)
CH01 T-1 LEVEL : OFF MODE : A
A
Setting alarm operation and display
CH01 T-1 LEVEL : OFF MODE : A
A
MENU
e00_l8hbd_xe_7.book Page 102 Tuesday, April 5, 2005 11:41 AM