Filter
Top Products
COMMAND LINE INTERFACE
Commands
350-9047 v3.0.1 DGy Model 201x User’s Guide 95
. . . . .
TiMingLIST [<1..160> [<1..160>]] |
[ACTIVE]
Displays the list of saved input and output timings.
If two numeric arguments are supplied, displays all
entries in the range. ACTIVE, displays only the
active timings.
TiMingLISTCLEAR (none) Deletes all user entries from the Timing List.
TiMingLISTLOAD <100 ...160> <name>
<hfp> <hs> <hbp>
<hact> <vfp> <vs>
<vbp> <vact> <hfreq>
<sync> <hpol> <vpol>
<il>
This command is used to create and save a user
timing set to the Timing List.
User defined entries may be saved to the list using
slots 100 - 160. Timing slots 1 - 99 are reserved for
factory defined timing settings.
The name parameter is a name that is used to
identify the timing set (for example mytiming3).
hfp - width of the horizontal front porch (pixels)
hs - width of the horizontal sync pulse (pixels)
hbp - width of horizontal back porch (pixels)
hact - width of the active picture area (pixels)
vfp - width of the vertical front porch (pixels)
vs - width of the vertical sync pulse (pixels)
vbp - width of vertical back porch (pixels)
vact - height of the active picture area (pixels)
hfreq - horizontal frequency (Hz)
sync - type of sync signal (analog 3, 4 or 5 wire)
hpol - polarity of horizontal sync pulse (0=negative,
1=positive)
vpol - polarity of vertical sync pulse (0= negative,
1=positive)
il - interlace (0 = non interlace, 1 = interlace)
Table 6-2 Input Commands (Continued)
Command Arguments Description