Filter
Top Products
OPERATION
Recording Clips
350-9047 v3.0.1 DGy Model 201x User’s Guide 63
. . . . .
3. Click the Input tab and to set up input parameters, including
RGB/DVI input selection, audio recording parameters, and
image adjustments. If the DGy 201x has not automatically
locked to the input source then the timing parameters can be
selected from the
Timing List. In the Timing List section, select
the timing that matches the input signal and click
Load. Refer to
the
Input Tab section on page 48 for details.
4. Click Close to return to the DGy Control Panel.
5. On the DGy Control Panel, click the Record button to begin
recording the new clip.
6. If the Enable Clip Auto Naming box (page 41) was checked on
the Record tab of the Options window, recording will begin
immediately. If the autoname is disabled, a clip name dialog box
will open providing the opportunity to name the clip.
Figure 3-26 Entering a New Clip Name
Navigate to the desired drive or folder. Enter a new clip name or
leave <auto> in the
Clip name box and click OK to begin
recording.
Note Spaces cannot be used in clip names.