Filter
Top Products
TECHNICAL SPECIFICATIONS
Connectors and Pinouts
350-9047 v3.0.1 DGy Model 201x User’s Guide 128
. . . . .
OUTPUT CABLES
Both the digital and analog outputs of the DGy 201x are provided on the
graphics output connector. Purpose built cables are available
commercially to provide connections for digital interfaces or analog
interfaces. The DGy 201x is provided with DVI 15-pin adapters for use
with analog devices, or alternatively an analog only output cable can be
purchased that provides a “break out” capability to separate RGB
connectors or sub miniature 15-pin D connector.
ETHERNET
. . . . . . . . .
CONNECTOR
CONNECTOR TYPE AND PINOUTS
The Ethernet connector is a standard RJ-45 type connector.
Figure A-2 Ethernet Connector
The 8-pin RJ-45 Ethernet connector has the following signals:.
STANDARD CABLES
Standard Ethernet cables are available commercially in many different
lengths. The standard cable is wired pin-for-pin (straight through) which
means that pin 1 of the connector at one end of the cable is wired to pin
1 of the connector at the opposite end of the cable. This type of cable is
used to connect the DGy 201x directly to the network — typically using
an Ethernet hub or switch. To connect directly from a PC to the DGy
201x, a crossover cable must be used (see the following section for
details).
Table A-11 Ethernet Connector Pinouts (EIA/TIA 568B)
Pin Signal Wire Color
1 TX Data + White/Orange
2 TX Data - Orange
3 RX Data+ White/Green
4 Blue
5 White/Blue
6 RX Data- Green
7 White/Brown
8 Brown