Filter
Top Products
COMMAND LINE INTERFACE
Commands
350-9047 v3.0.1 DGy Model 201x User’s Guide 105
. . . . .
NEXTMARK (none) The NEXTMARK command sends the DGy 201x
to the next event mark from the current position,
and cues there. To play from that spot, issue a
PLAY command. This command is valid only in
Play and Play/Pause modes.
NEXTMARK will only seek within the current clip,
and will not wrap.
PREVMARK (none) The PREVMARK command sends the recorder to
the previous event mark from the current position,
and cues there. To play from that spot you must
issue a
PLAY or PAUSE command. This
command is valid only in Play and Play/Pause
modes.
PREVMARK will only seek within the current clip,
and will not wrap.
SeekToMARK <marknumber |
markname>
The STMARK command sends the recorder to the
specified event mark, and cues there. To play from
that spot you must issue a
PLAY command.
STMARK will only seek within the current clip.
TimeCodeQuery [H | F] Returns the timecode at the current disk position.
Only valid in PLAY or PAUSE modes.
When used without an argument, the
TimeCodeQuery command returns the time in the
format yyyymmddhhmmss.
When used with the optional H argument, the
TimeCodeQuery returns the replay timecode with
resolution in milliseconds with the format
yyyymmddhhmmssxxx where the final three digits
(xxx) represent the fractional time in milliseconds.
When used with the optional F argument, the
TimeCodeQuery command returns the replay
timecode using the frame number. The first frame in
a file is identified as frame 0. Note that a clip may
consist of multiple files and that the maximum file
size is approximately 512 MB. This command
option is typically used for debug only.
Table 6-6 DGy 201x Play and Record Commands (Continued)
Command Arguments Description