RGB Spectrum DGy 201x DVR User Manual


 
INTRODUCTION
Record and Replay
350-9047 v3.0.1 DGy Model 201x User’s Guide 6
. . . . .
LOCAL PLAYBACK
For local playback, the DGy 201x is typically configured to replay from
the installed internal drive(s) to the analog RGB or DVI outputs, as
shown in the figure below.
Figure 1-1 Replay from Disk, Local Viewing
PC SOFTWARE REPLAY APPLICATION
A Windows
software application supplied by RGB Spectrum can be used
to replay DGy 201x recordings directly on a PC. The quality level will be
the same, but at reduced frame rates. This application works with the
standard Windows Media Player (version 9 and above) to provide basic
transport functions including play, pause and stop.
This application can be used to replay recordings in the following ways:
Recordings copied from a DGy 201x to the PC local drive using
TCP/IP file transfer protocol (FTP).
Recordings played from a DGy 201x removable drive inserted in
an appropriately configured PC equipped with a compatible
removable disk drive bay. The DGy 201x uses the ext2 file
system found with the Linux operating system. PCs running the
Windows operating system will require additional software in
order to mount the drive. This software is commercially
available.
Playback quality is high, but note that the playback frame rate is limited
by the performance of the selected PC. As an example, a PC equipped
with a Pentium® 4, 3GHz processor with 512 MB of memory will
typically play a 1280 x 1024 recording at 5 to 6 frames per second.
SIMULTANEOUS
RECORD/REPLAY
. . . . . . . . .
OPTION
The DGy 201x supports the optional playback from disk while
concurrently recording new material. Record and play start and stop
times are independent.
Additional codec circuitry is factory installed to use the Simultaneous
Record/Play option on the DGy 201x. The presence of this option can be
confirmed by viewing the
Web Control Panel Configuration Window
(page 22).
Source In
DGy
Codec
Record
Play
Loop Out
Output