Filter
Top Products
COMMUNICATIONS SETUP
Ethernet Control
350-9047 v3.0.1 DGy Model 201x User’s Guide 136
. . . . .
IP ADDRESS SETUP
. . . . . . . . .
VIA ETHERNET
DGy 201x’s IP address can be set directly via Ethernet, using a Telnet
session that enables remote login to the DGy 201x from a computer.
This procedure is not required if the IP address was set using the
method described in the
IP Address Setup via Serial Port section on
page 135.
Use the following procedure to set up the IP address with a Telnet
session:
1. Use an Ethernet crossover cable or Ethernet hub to connect
directly between the DGy 201x’s Ethernet port the network port
of the PC.
2. From the Start menu at the bottom of the Windows desktop
select Run...
3. In the Open dialog box type cmd as shown in the following
figure.
Figure B-5 Run Dialog Box
4. Click the OK to open the Windows command window.
5. At the command prompt in the command window type:
telnet <ipaddress> 8000
where <ipaddress> represents DGy 201x’s current IP address.
S Example: If the DGy 201x default IP address has not been
changed, it should be set to:
192.168.1.200
Using the default IP address shown above, in the command line
window, type:
telnet 192.168.1.200 8000
... and press ENTER.
Note For this procedure, the direct connection method is
recommended over the network method. This avoids
potential conflicts between DGy 201x’s default IP
address and the network.