Filter
Top Products
COMMAND LINE INTERFACE
Commands
350-9047 v3.0.1 DGy Model 201x User’s Guide 116
. . . . .
IPADDRess [ddd.ddd.ddd.ddd] Without an argument, this command reports the
DGy current IP address.
To change the DGy IP address, enter the command
followed by an argument.
Example: To set the IP address to 192.168.35.101,
type
IPADDR 192.168.35.101 and press Enter
Use the SYStemReSet command to reboot the unit
to activate the new IP address.
Default 192.168.1.200
IPSubNET [ddd.ddd.ddd.ddd] Without an argument, this command reports the
DGy current IP subnet mask.
To change the IP subnet enter the command
followed by argument.
Example: To set the IP subnet mask to
255.255.255.1, type
IPSNET 255.255.255.1 and press Enter
Use the SYStemReSet command to reboot the unit
to activate the new IP subnet mask.
Default: 255.255.255.000
IPGateWay [ddd.ddd.ddd.ddd] Without an argument, this command reports the
DGy current IP gateway address.
To change the gateway address, enter the
command followed by an argument.
Example: To set the gateway address to
192.168.35.1, type
IPGW 192.168.35.1 and press Enter
Use the SYStemReSet command to reboot the unit
to activate the new IP gateway.
MACADDRess (none) Reports the physical Ethernet (Media Access
Controller) address.
RestoreFactoryDefaults (none) Restores all user settings to their factory default
values.
SYStemReSet (none) Causes the DGy to reboot. This command allows
the system firmware to be restarted without having
to use the front panel power switch.
SHUTDOWN (none) Remotely shuts down the DGy.
Important: Do not remove the power cord from
the DGy until one to two minutes after issuing the
command. During shutdown, the power indicator on
the front panel will remain on, but the DGy is
inoperable. Failure to wait for the normal shutdown
procedure to execute may cause loss of data.
Table 6-10 Miscellaneous Commands (Continued)
Command Arguments Description