Filter
Top Products
4-7 SET UP Menu
4-70 Chapter 4 Menu Settings
Chapter 4 Menu Settings
6 To continue with changing the settings, repeat
steps 1 to 5.
7 Press the [F10] (SAVE/EXIT) button.
This saves all the changes, and returns to the SET
UP menu screen.
Checking the items with changed settings
In VTR SETUP menu item 131 “CHANGED MENU
HIGHLIGHT”, set ITEM SETTING to “on.”
Items for which the setting values are different from
the DEFAULT values appear in the VTR SETUP
screen in yellow.
To change the DEFAULT values in a menu
item
1 Use the cursor t button to make the item window
active, then with the cursor R and r buttons or the
MULTI CONTROL knob, move the cursor to the
item to be changed.
2 Press the [F7] (CHANGE DATA) button or the
cursor t button.
This opens a window for changing the setting.
For a sub item, further press the [F7] (CHANGE
DATA) button or the t button, to open the
window for changing the setting.
3 With the [F7] (CHANGE DATA) button, the
cursor R or r button, or the MULTI CONTROL
knob, change the setting.
4 Holding down the SET and ENTRY buttons at the
same time, press the cursor center button.
This saves the current settings as new DEFAULT
values for CURRENT DEFAULT.
The asterisks indicating the DEFAULT values
move.
Note
If you press the cursor center button first, the
setting values return to the PRESET values before
CURRENT DEFAULT is overwritten, and it is not
possible to change DEFAULT correctly.
To return the DEFAULT values to the factory
default PRESET values
Holding down the CLR and ENTRY buttons at the
same time, press the cursor center button.
This saves the factory default PRESET values as
the DEFAULT values for CURRENT DEFAULT.
5 Reset the current setting values if necessary, then
press the [F10] (SAVE/EXIT) button.
You can save the changed CURRENT DEFAULT
data set in DEFAULT VTR BANK or a “Memory
Stick.”
For details, see Section 4-1-10, “Saving and Recalling
DEFAULT Settings on a Bank” (page 4-13) and Section 4-
1-11, “Saving and Recalling DEFAULT Settings in a
‘Memory Stick’” (page 4-14).
Checking the items for which DEFAULT
values have been changed
In VTR SETUP menu item 131 “CHANGED MENU
HIGHLIGHT”, set DEFAULT SETTING to “on.”
Items for which the DEFAULT values are different
from the factory setting values (FACTORY PRESET)
values have the item number (or item name for a
subitem) in the VTR SETUP screen shown in yellow.