Filter
Top Products
Appendix A-43
Appendix
Items Relating to Digital Processing (902~)
Item SettingItem number
Function
902 FREEZE MODE [field]
field1
field2
frame1+2
frame2+1
Specifies the freeze (still-picture) mode and freeze timing
during manual freezing (by REMOTE1 IN (9P) or REMOTE2
PARALELL I/O (50P) connector or on the control panel) or
automatic freezing.
field: Freezes the odd or even field, depending on the timing
in freeze mode.
field1: Freezes the first (odd) field
field2: Freezes the second (even) field
frame1+2: Freezes the first and the subsequent second field
frame2+1: Freezes the second field and the subsequent first
field
In the case of freezing in playback modes other than normal
playback, the picture is frozen in frame mode only when
dynamic tracking is performing a frame operation. The
picture is frozed in field mode when dynamic tracking is not
operating.
The frozed picture does not change even if you change this
setting during freeze mode. The change to this setting
becomes effective the next time the VTR outputs a still
picture.
When the stop freeze function is enabled, regardless of the
setting of this item, the picture is frozen in frame mode only
when dynamic tracking is performing a frame operation, or is
frozed in field mode when dynamic tracking is performing a
field operation or when it is not operating.
903 FREEZE
CONTROL FROM
KEY PANEL
[momentary]
latch
Determines the freeze operation control by button
operations.
momentary: The picture is frozen only while the button is
held down.
latch: The picture is frozen when the button is pressed, and
remains frozen when the button is released.
The fozen picture is cancelled when the button is
pressed again.
Button operations
Freezing in odd or even (first or second) field is specified
by item 902. Distinction between the first or second field,
follows the distinction in the reference signal.
905 disable
[enable]
Enable or disables the stop freeze function.STOP FREEZE
CONTROL
910 ACTIVE LINE 1035
CONVERT MODE
1080k1035(CONV)
1080k1035(CROP)
Selects the conversion mode of the effective scanning line
number.
1080k1035(CONV): Convert the effective scanning line
number from 1080 to 1035 preserving the aspect ratio of
the image.
1080k1035(CROP): Convert the effective scanning line
number from1080 to 1035. The four sides of the image
are cropped, then it is horizontally expanded.
(Continued)