Filter
Top Products
4-2 HOME Menu
4-18 Chapter 4 Menu Settings
Chapter 4 Menu Settings
4-2-6 Setting the Preroll Time
(PREROLL TIME)
Set the preroll time by pressing the ALT/[F6]
(PREROLL) buttons.
You can set a preroll time of 0 to 30 seconds in 1-
second units. During editing on this VTR, a preroll
time of 5 seconds or more is recommended.
Setting the preroll time
1 Press the ALT/[F6] (PREROLL) buttons.
A data entry window appears.
2 Change the setting with the cursor R and r buttons.
You may also use the MULTI CONTROL knob.
3 Press the ALT/[F6] (PREROLL) buttons.
The data entry window disappears.
1,3
2
4-2-7 Selecting DMC Playback
(DMC)
In DMC (Dynamic Motion Control) playback mode,
the VTR plays back a tape segment at a specified
variable speed of –1 to +2 times normal playback
speed, memorizes the speed, then plays the segment
back at a later time at the memorized speed.
DMC playback is useful during on-the-spot telecasts of
sporting events for immediate playback and broadcast
of highlight scenes for which starting and ending
points have been set during recording.
For detail on the procedure for DMC playback, see
“5-4-4 DMC Playback” on page 5-11.
During tape editing using two SRW-5000 VTRs, you
can use DMC playback to control the playback speed
of the player VTR for editing at variable speeds (DMC
editing).
For detail on the procedure for DMC editing, see
“6-2-1 DMC Editing” on page 6-13.
4-2-8 Setting the Stop Code
(STOP CODE)
You can select the stop code detection mode
(recording/confirmation/deletion), and adjust the stop
position when a stop code is detected.
To call up the STOP CODE menu screen
Press the ALT/[F8] (STOP CODE) buttons in the
HOME menu.
Note
If DETECT STOP is set to “ON”, “D-STOP” appears
at the side of the cassette indication, as shown below.
LTC
TCR
INTRP DF F2
TAPE LOCK
DETECT
BEEP
off
DETECT
STOP
off
DETECT
ADJUST
off
REC
ADJUST
off
CODE
REC
off
CODE
ERASE
off
EXIT
00H 02M 39S18F
AIN --:--:--:-- AOUT --:--:--:--
IN --:--:--:-- OUT --:--:--:--
Edit points