Filter
Top Products
Chapter 4 Menu Settings 4-19
Chapter 4 Menu Settings
To detect stop codes: [F2], [F3]
When playing a tape on which stop codes are recorded,
you can select four different operating modes,
according to the settings of the [F2] (DETECT BEEP)
button and [F3] (DETECT STOP) button, as follows.
The tape transport modes and speed ranges in which
stop codes can be detected are as follows.
Note
In VAR mode, stop codes cannot be detected at ±0.03
times normal speed.
[F2] (DETECT
BEEP) button
[F3] (DETECT
STOP) button
VTR operation when stop
code is detected
OFF OFF No operation
OFF
ON
Stops (for NORMAL PLAY
only)
ON OFF A beeper sounds for 1
second
ON ON Stops (for NORMAL PLAY
only) and simultaneously a
beeper sounds for 1
second
Transport mode
and speed
Detected
Beeper
timing
Stop timing
NORMAL PLAY Yes When read
three times
Set by [F4]
(DETECT
ADJUST)
VAR, SHUTTLE
(0 to less than ±8
times normal
speed)
Yes When read
twice
No operation
REC, EDIT, JOG,
CUE UP,
PREROLL,
SHUTTLE (±8
times normal
speed or more)
No No
operation
No operation
Adjusting the stop position when a stop
code is detected: [F4]
When a stop code is detected, you can adjust the
position at which the tape transport stops in the
direction from the normal stop position toward the
SOM point, within the range of 0 to 150 frames, in
frame units.
1 Press the HOME button.
The HOME menu screen appears.
2 Press the ALT/[F8] (STOP CODE) button.
The STOP CODE menu screen appears.
3 Press the [F4] (DETECT ADJUST) button.
The setting display lights up.
4 Change the setting with the cursor R and r buttons.
You may also use the MULTI CONTROL knob.
5 Press the [F4] (DETECT ADJUST) button.
The data entry window disappears.
23,5 4
1
LTC
TCR
INTRP DF F2
TAPE LOCK
DETECT
BEEP
off
DETECT
STOP
off
DETECT
ADJUST
off
REC
ADJUST
off
CODE
REC
off
CODE
ERASE
off
EXIT
00H 02M 39S18F
AIN --:--:--:-- AOUT --:--:--:--
IN --:--:--:-- OUT --:--:--:--
STILL
SET 01 30 00 00
D-STOP
SS
HDCAM-SR
REMAIN:01H06M
! TC
D-STOP