Filter
Top Products
2-1 Control Panel
2-8 Chapter 2 Locations and Functions of Parts
Chapter 2 Locations and Functions of Parts
4 REC/EDIT (recording/edit) button
Press this button while holding down the PLAY button
to start recording.
If you press this button in play mode, manual editing
begins. After setting edit points, if you press this
button while the AUTO button is lit, automatic editing
is performed.
5 PLAY button
Press to start playback.
Press this button while holding down the REC/EDIT
button to start recording.
Pressing this button during recording or manual editing
changes the VTR to playback mode.
6 STOP button
Press this button to stop recording or playback.
When you insert the cassette, the VTR automatically
enters STBY OFF mode.
The STOP button flashes in the following cases.
• The [F2] (SERVO REF) button in the PF1 menu is set
to “input” but there is no video input signal.
• The [F2] (SERVO REF) button in the PF1 menu is set
to “ext” but there is no external reference video
signal.
• The input signal is out of synchronization with the
external reference video signal.
You can change the setting of the VTR SETUP menu
item 102 “REFERENCE SYSTEM ALARM” so that
the STOP button will not flash in these cases.
4 Display Section
1 Information display
The information display shows a number of different
pages. To change the page displayed, with no other
items selected in the menu display (HOME, TC,
VIDEO, AUDIO, PF1, and PF2), turn the MULTI
CONTROL knob while holding it down.
The currently selected page number also appears at the
upper right of the information display .
Page 1: System status
SYS: Shows the recording system information (signal
standard and tape format).
PB: Shows the information recorded on the tape
(signal standard and tape format) while being
played back.
FC: Shows the converted signal standard when an
HKSR-5001 board is installed.
TC: Shows the LTC/VITC and DF/NDF settings, or
the time code sent to the external monitor.
Page 2: system status
ACTIVE LINE: Shows the status of 1080/1035
conversion active line.
1080t1080
1080t1035(CROP)
1080t1035(CONV)
1035t1035
1035t1080(PANEL)
1035t1080(CONV): Shows the current
conversion status.
- - - - -: Cannot be converted.
OFF: No conversion done.
DOWN CONV. OUTPUT: Shows the output status
of the down converter.
ACTIVE: Output.
MUTING: No output.
EOS: Appears at the location of the timecode for the
valid end of the previous recording.
Page 3: Phase (OUTPUT)
HD SDI OUTPUT ADVANCE: Shows the phase of
the main line HD SDI output.
OFF: In phase with reference.
–90H: 90H (HD) advanced with respect to
reference.
DOWN CONV. OUTPUT ADVANCE: Shows the
phase of the down converter output.
OFF: In phase with reference.
–2H: 2H (SD) advanced with respect to reference.
1 Information display
2 REF SYNC indicators
3 PREREAD indicator
4 SERVO indicator
5 REC INHIBIT indicator
REC
INHIBIT SERVO
EXT
SD
EXT
HD
REF SYNC
INPUT
VIDEO
PREREAD
SYS: 23.98PSF 1080 4:2:2 HDCAM-SR
: ________ _____ _____ ________PB
: 59.94i 1080 4:2:2 FC
T*R 02:01.01:28
1