Filter
Top Products
Chapter 4 Menu Settings 4-41
Chapter 4 Menu Settings
4-4-7 TELE FILE Menu
The TELE FILE menu screen is different in HDCAM-
SR and HDCAM formats.
In HDCAM-SR format: The cassette has a memory
label attached as standard, and this screen allows
operations to read out, enter, or change the
cassette ID identification, recording format,
recording information, management information,
and so on. In the HDCAM-SR format, each
recording automatically adds recording
information. However, if the recording time is less
than 2 seconds, or if when recording ends the
measurement on the spool was not complete, then
no recording information is added. In the case of
an HDCAM-SR cassette, a cassette without a
memory label is ejected.
In HDCAM format: When an MLB-1M-100
memory label (optional) is attached to the cassette,
this screen allows operations to read out, enter, or
change the cue point information, log (IN/OUT
point) information, management information, and
so on. Using this information, cassette tape
management and tape editing efficiency can be
improved.
HDCAM-SR format TELE FILE menu
To open the TELE FILE menu
Do one of the following:
• Press the [F4] (TELE FILE) button while in the CUE
menu.
• Select “on” for the VTR SETUP menu item 124
“Tele-File MENU auto popup”. Then, with the
HOME, TC, VIDEO, AUDIO, CUE, or SETUP
menu open, insert a cassette into the VTR.
To change the information displayed in the
TELE FILE menu
Press the cursor T or t button.
Exiting the TELE FILE menu
Press the [F10] (WRITE/EXIT) button. The entered or
modified data is saved to the memory label and the
VTR exits the TELE FILE menu.
Note
If TELE FILE menu operations are prohibited while
the contents of a memory label are being modified,
only the data modified prior to the prohibition will be
saved to the memory label when the [F10](WRITE/
EXIT) button is pressed.
To exit the TELE FILE menu without saving
data to a memory label
Press the EJECT button. Or, press the ALT/[F2]
(UNDO ALL) buttons to display a message (in the
control panel display) requesting confirmation of the
undoing operation. Then press the [F2](UNDO ALL)
button while pressing down the SFT button. All
changes to the memory label will be cancelled.