Filter
Top Products
Appendix A-25
Appendix
ItemItem number Setting
Function
Specifies the type of editing for digital audio signals.
cut edit: Cut editing (discontinuity in audio signal may result
at the join, causing noise.)
cross fade: Cross-fade
(see figure below.)
fade in/out: Fade-out and fade-in
(see figure below.)
Notes
• The “t” in the figures above is the time set by item 811.
• When editing non-audio data, be sure to select “cut edit.”
• Noise may be produced during the editing of certain non-
audio data.
AUDIO EDIT
MODE
317
cut edit
[cross fade]
fade in/out
Set this item when the VTR is used as a recorder during
VTR-to-VTR editing. Specifies the action taken when the
recorder fails to synchronize with the player VTR.
off: Editing is not executed and the VTR enters STOP
mode.
on: The VTR automatically repeats the editing again (not
more than twice).
318 EDIT RETRY off
[on]
CROSS FADE
320 PLAY COMMAND
DELAY START
TIME
–30 frame
.
.
.
[0 frame]
.
.
.
+30 frame
This adjusts the time in frames required between the issue
of a playback command and this unit actually beginning the
execution of the command. This adjustment is useful for
synchronization between VTRs with widely differing start-up
timing.
PB
INPUT
IN
OUT
t
t
FADE IN/OUT
PB
INPUT
IN
OUT
t
t
312
ANALOG AUDIO
EDIT PRESET
REPLACE
[no def]
ch1
ch2
ch1+2
When the edit presets for VTR channels 9 to 12 are
specified by an editor or remote controller, these are set on
or off according to the analog audio edit presets.
no def: Not set.
ch1: Follows analog channel 1 edit preset.
ch2: Follows analog channel 2 edit preset.
ch1+2: Follows the edit preset for analog channel 1 or
analog channel 2.
Sub items
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH9
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH10
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH11
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH12
(Continued)