Filter
Top Products
Menu List
A-32 Appendix
Appendix
Item number SettingItem
627 CHAR WARNING
DISPLAY at dual
line mode
[off]
on
When item 626 is set to anything other than “time data
only”, this item specifies whether warning messages flash
on the second line or not.
off: Warning messages do not flash.
on: If a warning message exists, it flashes.
Notes
• Messages that have been cleared are not displayed.
For more information about clearing warning messages,
see “Clearing warning messages” on page A-9.
• When there are multiple warning messages, each
message flashes twice before it is replaced by the next
message.
628
REMAIN TIME
DISPLAY
[off]
10min
on
Sets whether to display remaining time on the tape in
superimposed character position.
off: Do not display remaining time.
10 min: Display remaining time when it is 10 minutes or
less.
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
Function
626 DISPLAY
INFORMATION
select
time data & status
time data & UB
time data & CTL
time data & VITC
[time data only]
When item 620 is set to “on”, this setting specifies the
content of text information output from the MONITOR
connector of SD SDI OUT, the SD OUT COMPOSITE
connector and FORMAT CONV. OUT (OPTION) connector.
time data & status: Timer counter display and status
information.
time data & UB: Timer counter display and user bits.
time data & CTL: Timer counter display and CTL.
time data & VITC: Timer counter display and VITC.
time data only: Timer counter display only.
630
TC CONVERSION
at 24F/25F off-
speed PB
[off]
on
Selects whether to convert the playback time code to the
operating frequency time code when tapes recorded with
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
(Continued)