Filter
Top Products
6-1 Basic Automatic Editing
6-12 Chapter 6 Editing
Chapter 6 Editing
Monitoring signals during editing
During editing, you can monitor the following video
and audio signals on a monitor connected to the
recorder VTR.
•Between preroll and IN points: Playback signal of
the recorder VTR can be monitored.
•Between IN and OUT points: Playback signal of the
player VTR can be monitored in E-E mode.
•Between OUT and post-roll points: Playback signal
of the recorder VTR can be monitored.
The video and audio signals that can be monitored are
shown in the diagram below.
In CONFI mode, you can monitor video and audio
signals that are just being edited.
Through a menu setting, you can also monitor signals
between preroll and postroll points, including portions
between IN and OUT points, through the CONFI
(confidence) heads during editing.
The CONFI setting is made using the VTR SETUP
menu item 017 “PB/EE SELECT MENU”.
To perform automatic editing
To carry out automatic editing, press the AUTO
button, turning it on, then press the REC/EDIT button.
During editing the indicator above the REC/EDIT
button lights up, and goes off at the end.
PB
(recorder VTR)
IN point
EE
(player VTR)
OUT point
PB
(recorder VTR)
OUT button
ENTRY button
AUTO button
PREVIEW/REVIEW button
REC/EDIT button
To stop automatic editing
Press the OUT button while holding down the ENTRY
button.
The point where the OUT button is pressed is treated
as an OUT point and editing stops.
To confirm the results of the editing
Press the PREVIEW/REVIEW button to confirm the
edit results. When the view ends, the tape rewinds to
the OUT point, then stops.
Modifying edit points for automatic editing
later
After you perform automatic editing, the time data of
IN, OUT, AUDIO IN or AUDIO OUT points remain
stored in memory. The stored data can be used later to
modify edit points or to execute automatic editing
again.
Follow the procedure below to modify edit points after
executing automatic editing.
1 In the HOME menu, press the ALT/[F10] (LAST
EDIT) buttons.
The edit points used in the last automatic edit are
restored.
2 Modify the edit points.
For details on modifying edit points, see “6-1-9
Modifying Edit Points” on page 6-9.
3 Press the REC/EDIT button.
The VTR performs automatic editing.
3
1