Filter
Top Products
Chapter 4 Menu Settings 4-17
Chapter 4 Menu Settings
4-2-5 Still-Picture Output
(FREEZE)
For still-picture output, press the ALT/[F3] (FREEZE)
buttons. The picture that was playing just before the
button was pressed will be frozen on the screen. Make
the field or frame selection using the VTR SETUP
menu item 902 “FREEZE MODE”.
To maintain the still-picture
Set the VTR SETUP menu item 903 “FREEZE
CONTROL FROM KEY PANEL” to “latch”.
The still-picture output is maintained until the button is
pressed again.
To temporarily output a still-picture
Set the VTR SETUP menu item 903 “FREEZE
CONTROL FROM KEY PANEL” to “momentary”.
A still-picture is output as long as you hold down the
button.
Stop-freeze function
To automatically output a still-picture when the VTR
is changed to stop mode, set the VTR SETUP menu
item 905 “STOP FREEZE CONTROL” to “enable”.
Note
Regardless of the setting of the VTR SETUP menu
item 902 “FREEZE MODE”, stop-freeze is a frame-
freeze picture during playback of a PsF recorded tape,
and a field-freeze picture in other modes.
4-2-3 Selecting the Edit Mode
and Edit Channel (ASSEMBLE,
INS TC, INS VIDEO and INS
AUDIO)
Select assemble or insert edit mode.
Selecting assemble edit mode
Press the [F3] (ASSEMBLE) button in the HOME
menu.
Selecting the insert edit mode
Press one of the following buttons in the HOME menu:
[F4] (INS TC), [F5] (INS VIDEO), [F6] (INS AUDIO).
For more information about editing operations, see
“Chapter 6 Editing” on page 6-1.
4-2-4 Preread Settings
(PRE READ)
This setting allows pre-reading (reading before
writing) in insert edit mode. To select pre-reading,
press the ALT/[F1] (PRE READ) buttons.
Pressing the button cycles the settings through on/off.
on: Preread. (Preread either video signal or audio
signal. In this case follow the EDIT PRESET
setting.)
off: No pre-reading
The pre-read function can be used for pre-read editing.
[F1] button
PREREAD indicator