Filter
Top Products
5 - 22
5.6 Monitor/Test
5.6.2 Offset/gain setting operation
5
UTILITY PACKAGE (GX Configurator-TI)
5.6.2 Offset/gain setting operation
Perform the offset/gain setting operation in the following sequence.
(1) Displaying the "CH Offset/gain setting" screen
Display the "CH Offset/gain setting" screen of the setting target channel, referring to
the operation described in Section 5.6.1.
(2) Switching to the offset/gain setting mode
Note) Do not perform this operation when the setting has already been
in the offset/gain setting mode.
Set "Offset/gain setting mode" in the Setting value field of "Mode switching setting"
and click the button. "Offset/gain setting mode" will be set in the Current
value field of "Mode switching setting status".
(3) Enabling the conversion enable/disable setting
(a) Set "Enable" in the Setting value field of "Conversion enable/disable setting" and
click the button.
(b) Set "Request" in the Setting value field of "Operating condition setting request"
and click the button. "Request" will be set in the Current value field.
(c) Set "OFF" in the Setting value field of "Operating condition setting request" and
click the button. "OFF" will be set in the Current value field.
(4) Adjusting offset/gain values
(a) Adjusting offset values
1) Selecting "Offset setting"
Select "Offset setting" in the Setting value field of "CH Offset setting channel
setting" and click the button.
2) Setting an offset value
Enter a desired value in the Setting value field of "CH Offset temperature
setting value" and click the button.
3) Determining the offset value
Select "Request" in the Setting value field of "CH Channel change request"
and click the button.
Confirm that "CH Channel change completion flag" has changed to
"Completed", and then select "OFF" in the Setting value field of "CH Channel
change request" and click the button.
Select "Invalid" in the Setting value field of "CH Offset setting channel
setting" and click the button.
(b) Adjusting gain values
1) Selecting "Gain setting"
Set "Gain setting" in the Setting value field of "CH Gain setting channel
setting" and click the button.