Filter
Top Products
3
SPECIFICATIONS
3.4 Buffer Memory
3.4.9 Averaging processing selection (Un\G24 and Un\G25)
3 - 35
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PROCEDURES AND
SETTINGS BEFORE
SYSTEM OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
3.4.9 Averaging processing selection (Un\G24 and Un\G25)
(1) Sampling processing or averaging processing (time average, count
average, moving average or primary delay filter) is selected for each
channel.
(2) The default value is set to "Sampling processing" for all channels.
(3) To activate the setting, turning ON/OFF Operating condition setting
request (Y9) is required.
(4) The following table shows the settable range.
[Example]
To set count average, time average, primary delay filter, and sampling processing for
Channel 1, 2, 3, and 4 respectively, set "0412
H" in Un\G24.
POINT
If a value out of the setting range is set, sampling processing is performed.
Table 3.12 Processing method and setting value
Processing method Setting value
Sampling processing 0H
Time average 1H
Count average 2H
Moving average 3H
Primary delay filter 4H
b15 b12 b11 b8 b7 b4b3 b0
CH8 CH7 CH6 CH5
CH4 CH3 CH2 CH1
Un\G24 (Averaging processing
selection CH1-4)
Un\G25 (Averaging processing
selection CH5-8)
to
to
to to