Filter
Top Products
APPX - 12
Appendix 1 Dedicated Instructions
Appendix 1.4 G(P).OGSTOR
APPENDICES
(2) Operation error
An error occurs in any of the following cases and the corresponding error code is
stored into the completion status area (S)+1.
(3) Program example
In this program example, when M11 turns ON, the offset/gain values are restored to
the Q68RD3-G mounted in the position of I/O number X/Y10 to X/Y1F.
Table APPX.11 List of errors
Error code Description
161
The G(P).OGSTOR instruction was executed in the offset/gain setting
mode.
162 The G(P).OGSTOR instruction was executed consecutively.
163
The G(P).OGSTOR instruction was executed for the model that
differs from the model for which the G(P).OGLOAD instruction had
been executed.
Processing at the time of error completion
Dedicated instruction
(GP.OGSTOR)